Are you happy with your IC System? Application Guarantee – success guaranteed! Switch to Metrohm now! There are good reasons to switch to Metrohm! 02 You save money ... because you will need fewer consumables • No syringe filters • No filter caps • Metrohm anion suppressor lasts for 10 years – guaranteed You save time ... because fully automated sample preparation is an integral part of the system • Filtration: any particles are removed from the sample by Inline Ultrafiltration • Dilution: the optimum dilution factor is calculated automatically and the sample diluted • Calibration: calibrations are performed automatically based on a single multi-ion standard You will feel safer ... because your Metrohm IC System is self monitoring • Out of spec parameters are reported in plain text • Intelligent components (columns, pumps, detector) log in automatically & report if service is required • In case of an emergency you are protected by your Metrohm Care Contract The difference is in the details: fully integrated & automated sample preparation! Inline Ultrafiltration – forget about syring filters! 03 Inline Ultrafitration combines sample introduction with immediate filtration. Because of this unique technical feature, filters with a pore size of 0.2 μm can be used for 100 or even more samples. • Fully automatic filtration (0.2 μm) of samples during sample introduction • More than 100 samples with one filter, because carryover from sample to sample is negligibly small (<0.1%) • Cost-saving solution for routine analysis Schematic of ultrafiltration cell Inline Dilution – leave the pipette in the drawer! Inline Dilution means all you need to do is place your samples on the rack of your sample processor. The system automatically calculates the optimum dilution factor and analyzes the sample. Thus your results are always reliable, because they are within the calibration range. • Unique dilution system based on logical decisions of the system • Accurate and reliable results, irrespective of the initial concentration of the sample • Automatic sample dilution during sample introduction Automted calibration – things can be so easy! Of course, not only samples, but also standards can be diluted. Consequently, Metrohm offers you the possibility of automatic calibration, i.e., you only need to prepare a single multi-ion standard. The system dilutes this standard with different dilution factors and thus carries out a multipoint calibration. • Automatic calibration; preparation of a single multi-ion standard is enough Schematic of logical Inline Dilution • High flexibility: one method for all dilution factors between 1 and 100 • Sample concentrations in the range 1:10’000 can be analyzed reliably with automatic calibration Metrohm – outstanding quality guaranteed! www.metrohm.com G, CH-9100 Herisau ohm A witzerland by Metr , printed in S SW 10 Subject to change Layout Ecknauer+Schoch A 8.000.5170EN – 2015-